To get the best out of your bandsaw you Must Begin with a correctly:

  • Corrected blade
  • Guide cubes
  • Push bearings
  • Squared table

It’s essential to look at every one of these factors each time you use your saw, alter your blade, or any time your blade and cubes show some wear. A correctly corrected bandsaw is a joy to use. But if adjusted, it can be a significant frustration.

There are five easy steps one must execute in arrangement, to guarantee a properly calibrated bandsaw.

  1. Tension the Blade

To do this, you utilize the “blade trimming” knob which protrudes over the event of the greatest blade. Some saws have signs for various blade widths. All these are only approximate signs, so begin by strengthening the blade that has been set on the wheels.

  1. Tracking the Blade

Before you Begin to plug into the machine, Make Sure That the guide blocks and Thrust bearings are entirely clear of the blade. Rotate the blade wheels. CAUTION: Do not put your finger through the spokes of this wheel. You could seriously hurt or lose a finger. Since it’s rotated, the blade must proceed into the middle of the rubber tire onto top and the underside wheels. If the blade doesn’t appear to centre, you need to correct the”upper wheel tilt knob” while you hand-turn the wheel. Turn the wheel until you get it monitoring on the middle of the rubber tires as near as possible. You might require a little more pressure on the blade, but do not too compress the wheels.

  1. Fixing the Guide Blocks/Pins

Proceed the best guide blocks/pins forward or back so the front borders will be directly behind the blade teeth. Have a sheet of paper how big a $5.00 bill and fold it in the trunk around the blade. Transfer the blade and bank notice involving the guides/pins and without deflecting the blade, then tighten the guides/pins into some wonderful fit round the paper. Do the Exact same for the underside guide/pins.

  1. Ranking the Thrust Bearings

Move the very best thrust bearing until it’s nearly touching the blade. It shouldn’t roll when you hand-turn the blade but if roll once you cut timber. Do the exact same for the bottom bearing. You should now get you’re:

  • Blade
  • Guides
  • Thrust bearings
  1. Square that the Table

The last step is to place the table 90 degrees to the blade. Put a Little square (4″ to 6″) on the desk against the blade. In the rear, bottom of the desk, there should be an adjusting bolt letting you modify the angle of the table. Turn the bolt till the square indicates the table and blade are 90 degrees to one another.

NOTE: Every time you change the blade, then you should go through steps 1 through 5.When you have finished working with your bandsaw, and won’t be using it for a little while, release the blade strain. There’s not any point in developing a level side in your own rubber tires.